How much of your day is actually spent blasting? If you work on pipe I.D., probably far less than it should be. Every setup, every adjustment, and every restart for the next run eats into the hours that should go to blasting pipe, and that lost time adds up fast.

That's the problem the SpinBlast 2 was engineered to solve. It's the next generation of our I.D. pipe blasting tools, and its biggest advance is a new spring-loaded rear-end housing. The SpinBlast 2 (Part No. CT SB636A2) is shipping now.

The Hidden Cost of Manual Adjustments

Blasting the inside of a pipe depends on one detail: the rubber-lined nipple has to be held under the right amount of pressure. On other tools, that means a manual adjustment. Someone has to set the pressure and then stop to set it again whenever it needs attention. It's a small task, but it comes back with every setup, and each time it sets the job back. Just how far back depends on how well the adjustment gets done.

Meet the Spring-Loaded Housing

The spring-loaded rear housing holds constant pressure on the rubber-lined nipple, with no operator adjustment.

The SpinBlast 2 handles that hard work for you. The spring-loaded rear-end housing presses against the rubber-lined nipple with steady, continuous force, and it keeps doing so automatically, run after run. That gives the operator more time to finish the job efficiently, without the hassle of stopping to adjust the pressure.

What a Spring Means For Your Productivity

Every benefit traces back to that one design choice. With no manual adjustment, setup between pipe runs is faster, so more of your day goes to blasting instead of getting ready to blast. Constant pressure on the nipple supports a more consistent blast profile, run after run. Fewer adjustments also mean fewer interruptions and less downtime.

You won't have to replace your equipment, either. The SpinBlast 2 connects to most abrasive blasting machines, so it's ready to work with what you already have.

Upgrading From Your Current SpinBlast

Whether you're upgrading from a current SpinBlast or looking for an easier way to blast pipe I.D., the SpinBlast 2 is built to improve your productivity.

Upgrading from your current SpinBlast? Take 10% off.*

Call 1-800-CLEMTEX or Contact Us and we'll apply the discount to your order.

*Limited to one use per customer.

Shop the SpinBlast 2